What did you do to/in your 5th Gen today?!

I just got back from spending this past week in Ouray, CO. I don't think I'll ever get tired of those trails, and the scenic views!

hiRFOoVh.jpg


VPaFqUCh.jpg


DnK0tU9h.jpg


scEETg3h.jpg


gz9cBkQh.jpg


KJ4RHcSh.jpg


CZNolB5h.jpg


0Fj8Pk1h.jpg


0lUg4I3h.jpg

Jesus... I'm definitely living in the wrong state.
 
Just picked up these bad boys from Cali Raised Offroad in SoCal!

Hope to get them installed by Friday so I'm ready for the rutted Cleghorn trail on Sat!
 

Attachments

  • 3378EEDA-C451-4DAF-BED9-3B9AE00ABBD5.jpg
    3378EEDA-C451-4DAF-BED9-3B9AE00ABBD5.jpg
    120.8 KB · Views: 976
I installed the ARB diff breather kit today. My long term plan is to install the Shrockworks dual battery kit and the Bandi compressor bracket over the smog pump relocate so I put the breather manifold as close as possible to the air intake. I've been installing anything that requires drilling into the truck using rivnuts instead of self-tapping screws but I kinda butchered the rivnuts installation this time, it was hard to reach the area to drill and install them. I'm praying I left enough slack in the hose for the axle to droop but 99% of my driving is on-road so my chances of maxing the suspension travel are very low.
dc9139e33725ceaf5cac69cc04e87ad2.jpg


Sent from my Pixel 2 using Tapatalk
 
just got back from two weeks in CO / Moab

Mosquito

50188005438_ee88fa18b6_k.jpg



check out the flex on my new 5100s

50188802872_ff7717caab_k.jpg


this was right after crossing the actual pass. I came across a section of road that was snow-covered and looked very sketchy. i was mulling over whether or not i wanted to attempt it, when some monster 4th gens came up behind me, and a rube in a ruby came up from the other side. the 4th gen guys convinced the ruby to attempt to cross the snow, with the understanding they would winch him out if he got stuck. he immediately got stuck/started sliding down the mountain, so they stacked winches on winches to pull him across. ultimately the 4th gens (and a taco with 35+s, and an FJ using a winch) got through, but one guy had to bail and just go straight down the mountain. i ultimately turned around and got to see the pass for a 2nd time!
the photo makes it look not that tough, but the snow was slick af, and you could not make ruts in it, so it was very tippy, and the rocks to the right were very loose. glad i turned around!

50188802837_13f5f6362b_k.jpg



Engineer

50188550691_57d9f7deda_k.jpg


50188159893_c21081313f_k.jpg


Cinnamon

50188550566_e907b892bc_k.jpg


I also did Ophir on the way to Telluride but didn't get any photos.

Mosquito was by far the rockiest. very slow and extremely bumpy, and as i mentioned, i didn't even get to finish it. engineer, cinnamon, and ophir were very fun and easy, no spotting required. gorgeous part of the world.
 
Last edited:
Decided to kick into simple modification mode...

- LED High beams
- LED Low beams
- Cupholder Hero kit (Black)
- HuskyLiner Weatherbeater floor mats all around + cargo area.
- Heatshield sunshade
- JDMcar center console organizer

Next up, put my license plates on, recovery hitch, and bigger badder better mods.
 
Drove the Trans Wisconsin Adventure Trail this past weekend to beat the COVID blues. This is mostly backroads, logging roads, and forest roads stretched from the Illinois/Wisconsin border to Lake Superior.

cf180b9f0258b88c9a2cc42d3c60d7bf.jpg

ee89743bb13ec13149ef0602ba08a484.jpg

5ff31f73e59c1e0c9485940a0eef7ba0.jpg

c5ad943ad3b9f60f2e2726624b870b1f.jpg

cbc349531e9626cda2efc34dadbd8e04.jpg

16051320100a2427419442956b78b1f0.jpg

0b555684cc3730d957eff71a3ba37491.jpg



Sent from my iPhone using Tapatalk
 
Last edited:
Finally got to test on all the mods together. Pretty happy with my “build”. Had no issues come up.

I keep thinking about getting steel and a winch. Suppose I need to start thinking about coil choices and what have you. For now I save money and enjoy the truck as is.
 

Attachments

  • 6156D6FD-F98A-4559-90B9-C8CACBC83AF9.jpeg
    6156D6FD-F98A-4559-90B9-C8CACBC83AF9.jpeg
    93.4 KB · Views: 709
  • 67EA76C8-FCE8-4B86-9C4B-3D5F6A312866.jpeg
    67EA76C8-FCE8-4B86-9C4B-3D5F6A312866.jpeg
    105.6 KB · Views: 708
  • A096320A-9746-4DAE-9DD0-698458D1CAF0.jpg
    A096320A-9746-4DAE-9DD0-698458D1CAF0.jpg
    71.4 KB · Views: 709
  • FD6D4A2B-16BF-463F-913C-C0208B22C612.jpg
    FD6D4A2B-16BF-463F-913C-C0208B22C612.jpg
    73.2 KB · Views: 709
  • E6620435-7725-4556-9E9A-E7EEE5DE789E.jpeg
    E6620435-7725-4556-9E9A-E7EEE5DE789E.jpeg
    129.4 KB · Views: 703
Lift kit and 285s are on. Westcott Designs Fox TRD Pro Front Lift kit and Camburg 1.25 Uniball UCAs up front. Dobinsons C59-599 Coil Springs in their red finish for the rear. Tires are 285/70/17 Falken Wildpeak A/T3W C-load range. Super happy with the set-up and it still rides very nice, albeit a touch firmer than stock. Parts and install all done through my buddy Monroe over at Michael's Toyota in Bellevue. For anyone in the greater Seattle-area, I highly recommend him for anything aftermarket.
 

Attachments

  • Lifted_01_4MP.jpg
    Lifted_01_4MP.jpg
    139.9 KB · Views: 1,343
  • Lifted_03_4MP.jpg
    Lifted_03_4MP.jpg
    138.9 KB · Views: 1,340
Not to clutter the thread, but been looking for a roof rack that jumped out at me.. and this is it. Just ordered the upTOP Overland Bravo roof rack this morning, can't wait. Love the lines on that thing really matches the truck well, and there's a sale right now, I paid $799 shipped which is fantastic. Cheers brother.

Definitely one of the cleanest looking racks IMO. I love it! The shop is local to me and I've met the guys that own uptop and they're some super cool dudes. You'll love it. Can't wait to accessorize mine some more haha
 
this was right after crossing the actual pass. I came across a section of road that was snow-covered and looked very sketchy. i was mulling over whether or not i wanted to attempt it, when some monster 4th gens came up behind me, and a rube in a ruby came up from the other side. the 4th gen guys convinced the ruby to attempt to cross the snow, with the understanding they would winch him out if he got stuck. he immediately got stuck/started sliding down the mountain, so they stacked winches on winches to pull him across. ultimately the 4th gens (and a taco with 35+s, and an FJ using a winch) got through, but one guy had to bail and just go straight down the mountain. i ultimately turned around and got to see the pass for a 2nd time!
the photo makes it look not that tough, but the snow was slick af, and you could not make ruts in it, so it was very tippy, and the rocks to the right were very loose. glad i turned around!

50188802837_13f5f6362b_k.jpg

Thats David Crosby. Sweet 4th gen build. Definitely makes me miss mine.
 

Members online

Forum statistics

Threads
278,317
Messages
3,554,126
Members
248,016
Latest member
Advally Service

Trending content

Back
Top