What Did You Do To Your 3rd Gen Today?

Status
Not open for further replies.
Finally got my cb mounted

544344_352041941567386_1607606098_n.jpg
 
Nice head unit. I have the same one. After a out 2 years mines starting to crap on me. Cb install looks clean too!

thanks i got mine with the runner when i bought it a year ago only thing wrong is the face dont wanna flip down(open) wen i want to change cds
 
Tightened the cables for the cruise control, transmission kickdown and throttle. The throttle was a pain cause the nut on the left side was stuck so I had to get a pair of vise grips to hold the bolt in place while I loosened the nut. But what a difference this makes. No play in the gas pedal. When I step on the gas it goes with no lag. Next up a bath and full detail when my stuff gets in from amazon. Can't wait!!
 
...Seems like every time I spend even a millisecond thinking about my storage setup I end up modifying it again. This time added a raised slide out for the kitchen, cooler and sleeping pad. Now with almost everything on the packing list in a specifically designed slot, I can get to camp, grab a chair, and just crack open a :beer: and :snacker: while everyone else unpacks and sets up.. Time for a test run.
 

Attachments

  • Truck Beach 2.jpg
    Truck Beach 2.jpg
    62.4 KB · Views: 778
  • 4runner-fridge-slideout.jpg
    4runner-fridge-slideout.jpg
    46.5 KB · Views: 956
...Seems like every time I spend even a millisecond thinking about my storage setup I end up modifying it again. This time added a raised slide out for the kitchen, cooler and sleeping pad. Now with almost everything on the packing list in a specifically designed slot, I can get to camp, grab a chair, and just crack open a :beer: and :snacker: while everyone else unpacks and sets up.. Time for a test run.

Is that top photo real? If it is I think that needs to go in a corona ad. Sweet set up.
 
Took the factory roof rack off. Can't ever see using it and if I do it's not that hard to put back on. Plus it makes it easier to do a clay bar and total detailing of the Runner next week.
 
Removed the starter and replaced the contacts and the plunger. It was surprising that the contacts were not too bad, but the copper on the plunger was way worn out.

The parts totaled a whopping $16 :)

agytaqev.jpg

ave6a7a3.jpg
 
ugh, P0171 code

Cleaned the MAF, hoping it fixes the CEL. Figures it throws a code as smog is due.:boxer:
Weird occurence sitting at a stop light (4runner warmed up) look at the AFR gauge and see it going up, up 17...18....19.9 at idle, thinking WTF! look at the scan gauge says "Open Loop" then CEL trips.
:bash:
 
Status
Not open for further replies.

Members online

Forum statistics

Threads
278,316
Messages
3,554,120
Members
248,016
Latest member
Advally Service

Trending content

Back
Top