What Did You Do To Your 3rd Gen Today?

Status
Not open for further replies.
Yea pleas do. I have this usb charger also. Haven't hooked it up. I wish it had its own independent LED wire.



I have one in mine as well, I ran mine off ot the cigarette lighter wires to the center console. I like that it stays lit up and its easy to find at night. If you just use a quick charge cable with it, phones charge well.


Sent from my iPhone using Tapatalk
 
I took this picture. image.jpg

Removed the upright crossbars on my roof rack. Have 9 roof top rails creating a sort of basket base. Working on a low profile rail.
Also painted the wheel caps black.
 

Attachments

  • image.jpg
    image.jpg
    140.5 KB · Views: 1,074
Installed OME lift w/o spring compressor

June 3 spent 6 hrs in 110 F temps installing front lift kit used a technique I found in Utube where 2 guys installed bilstien 5100 & longer tundra coils in their 2003 taco
 

Attachments

  • IMG_0365.jpg
    IMG_0365.jpg
    124.9 KB · Views: 670
  • IMG_0367.jpg
    IMG_0367.jpg
    126.8 KB · Views: 681
  • IMG_0376.jpg
    IMG_0376.jpg
    131.1 KB · Views: 697
  • IMG_0374.jpg
    IMG_0374.jpg
    126.1 KB · Views: 685
  • IMG_0379.jpg
    IMG_0379.jpg
    136.5 KB · Views: 705
  • IMG_0385.jpg
    IMG_0385.jpg
    124.7 KB · Views: 685
  • IMG_0388.jpg
    IMG_0388.jpg
    109.8 KB · Views: 697
  • IMG_0395.jpg
    IMG_0395.jpg
    130.9 KB · Views: 699
Everyone else likes that too ;)


Sent from my iPhone using Tapatalk



Everything installed. It's not the prettiest or a show car. I can't figure out how to fully cover the hole so you don't see the cut. Because the box behind the plastic cover is a seperate piece. Because I want to be able to remove the trim when needed and not have to unscrew the subwoofer out. So basically I can remove anything like it was and be able to fix if something is broken.

Like I said, the box is beyond small and not even close to right volume. It doesn't really hit on low volume but turned up it hits good. It's single 10" sub.

I have 9 wire running. It's basically 1 wire with 9 individual wires. So I can tap into all the speaker wires and just hook them up to my 5 channel amp. This eliminates me from running seperate wires to speakers. And leaves me with 1 wire which sends power to the sun from ignition.
 
Awhile back I picked up a bumper off of Craigslist. The guy mentioned that he had just done the tundra upgrade and had pulled off his old brake pads and rotors that only had 1,000 miles on them. He said I could have them for free.

I finally got around to installing them today; they work just like new.

Thanks Craigslist guy!
 
I have one in mine as well, I ran mine off ot the cigarette lighter wires to the center console. I like that it stays lit up and its easy to find at night. If you just use a quick charge cable with it, phones charge well.


Sent from my iPhone using Tapatalk

I was thinking that to. That running it of cigarette outlet would be ok. As long as your just charging a cell phone.
 
I was thinking that to. That running it of cigarette outlet would be ok. As long as your just charging a cell phone.



I actually removed my cigarette lighter a while back and had the wires to use. I have my CB and my USB running off of the original wires with no problem. There are times that I have to charge my GoPro with the USB too. I have had no problems with it charging anything so far.


Sent from my iPhone using Tapatalk
 
Details...

I was up early to wash, clay bar, compound, polish, and seal the 4Runner in order to try and fix the paint (dog hangs out window and his nails scratch the paint pretty badly). The picture below is after washing and claying, halfway through the compound process; front door has been done and rear hasn't. Before compounding the front door looked just as bad as the rear.
 

Attachments

  • image.jpg
    image.jpg
    128.6 KB · Views: 681
I discovered a crack in my driver side valve cover. Just replaced gaskets on those less than 2 weeks ago :ybrick: Anyone have a driver side valve cover they'd be willing to sell?
 
Lots of stuff on the horizon. I got my AOR bumper back from being powder coated. When I swap bumpers I will be installing my transmission cooler. I also just placed my group buy order for my SPC LR UCAs. I am starting to gather parts for my lift. Woot!

Oh, and this happened the other day.
 

Attachments

  • IMG_20160629_130655.jpg
    IMG_20160629_130655.jpg
    50.3 KB · Views: 525
Status
Not open for further replies.

Members online

Forum statistics

Threads
278,316
Messages
3,554,120
Members
248,016
Latest member
Advally Service

Trending content

Back
Top