slowginjoe
New member
I'll take one please!
20 FREE red T4R.ORG stickers to celebrate our 2nd anniversary!
- Thread starter GatorGreg
- Start date
Okay, that's it. If you're one of the 20 listed below please PM me your mailing addy if you haven't already done so 
1. sharp4runr
2. rsp685
3. Luxury
4. boston_kevin
5. Derek
6. rchavez1
7. MoveOvr
8. Border411
9. TexasGuy68
10. T4R04LTD
11. the_josh
12. linhsy
13. MWS
14. pantera24
15. Noloc
16. Bobby
17. ToyDiehard
18. slowginjoe
19. jj8111
20. CHRIS240
1. sharp4runr
2. rsp685
3. Luxury
4. boston_kevin
5. Derek
6. rchavez1
7. MoveOvr
8. Border411
9. TexasGuy68
10. T4R04LTD
11. the_josh
12. linhsy
13. MWS
14. pantera24
15. Noloc
16. Bobby
17. ToyDiehard
18. slowginjoe
19. jj8111
20. CHRIS240
16 stickers went out in Saturday's mail and 3 are going out today (Derek, T4R04LTD & Noloc).
I still need an addy from CHRIS240.
If you haven't seen them before here are the installation steps
Installation steps
1) SLOWLY peel the front piece of paper off the backing paper at about a 45 degree angle, CAREFUL to make sure the letters remain stuck in proper position to the front piece of paper.
2) stick the front piece of paper with the attached letters to a clean dry window, and rub it on REAL good. Note: You want to make sure during this step that for alignment purposes you are using the top edge of the actual letters since the top edge of the paper they're attached to is probably not exactly in parallel with the letters.
3) SLOWLY peel off the front paper allowing the letters to remain stuck to the window.
Note: During step one (1) above, some of the letters may be stubborn about coming off the backing. If this happens, carefully lay the front piece of paper back over the letter, push hard on it with your thumb, and repeat step one.
I still need an addy from CHRIS240.
If you haven't seen them before here are the installation steps
Installation steps
1) SLOWLY peel the front piece of paper off the backing paper at about a 45 degree angle, CAREFUL to make sure the letters remain stuck in proper position to the front piece of paper.
2) stick the front piece of paper with the attached letters to a clean dry window, and rub it on REAL good. Note: You want to make sure during this step that for alignment purposes you are using the top edge of the actual letters since the top edge of the paper they're attached to is probably not exactly in parallel with the letters.
3) SLOWLY peel off the front paper allowing the letters to remain stuck to the window.
Note: During step one (1) above, some of the letters may be stubborn about coming off the backing. If this happens, carefully lay the front piece of paper back over the letter, push hard on it with your thumb, and repeat step one.
Luxury
New member
Sticker Arrived
I got mine yesterday too. Greg and Thai really do deserve a round of applause. Thanks guys......it is probably pretty obvious that I love this site by how much I've been posting.
Where is everyone going to put their stick? I'm thinking about the bottom of the rear side window.
I got mine yesterday too. Greg and Thai really do deserve a round of applause. Thanks guys......it is probably pretty obvious that I love this site by how much I've been posting.
Where is everyone going to put their stick? I'm thinking about the bottom of the rear side window.
boston_kevin
New member
Thanks!
Got mine yesterday, but I have to clean her up before I bestow that badge of honor.
Thanks for making this a great site and a wealth of information!
Got mine yesterday, but I have to clean her up before I bestow that badge of honor.
Thanks for making this a great site and a wealth of information!
Similar threads
