2011 Door panel removal?

[4runnerPA]

Anyone have a link to instructions on how to remove the door panels on a 2011?

Looking to dynamat the doors and cannot find instructions anywhere.

thanks!

 

[Antman]

bump- I just tried to remove mine and couldn't get it off completely. Sail panel off, 2 screws @ handle, and pulled the panel out and up. Something is hanging up by the door handle area. I'm afraid to yank too hard! Anybody know what I'm missing??? Thanks.

 

[mag10]

^behind the actual door handle there is a small plate that snaps into place. Use a flat head, and carefully pop this piece out and you will then see a phillips screw anxiously awaiting removal.

 

[Antman]

...tricky! Got it, thanks alot!

 

[TOYSTRY]

How many screws total are there to remove and where are they?

 

[Antman]

3 screws. Two behind the little "trap doors" above and below the door pull. Pry out the caps for these. Third is behind the door handle. Put a screwdriver behind the plastic panel (towards the rear of the truck) and pop it off to get to the last screw. That's it!

 

[WhiskeyCop]

Anyone have a link to instructions on how to remove the door panels on a 2011?

Looking to dynamat the doors and cannot find instructions anywhere.

thanks!

4Runner Factory Service Manual