rigtec
New member
I just found this you tube video; have a look and see just How to perform a Parasitic current draw test
Cheers
Cheers
I haven't been able to do so yet myself but you really should have a cutoff switch between the winch and the battery anyway. Just for safety in case the solenoid locks on while the winch is operating. But the 2 questions about your compressor probably have more validity in this case.
DOH!
Let's try it again:
https://www.bluesea.com/products/3000/HD-Series_Heavy_Duty_On-Off_Battery_Switch
Sorry, been a long day!!!
Did you get the version with or without AFD.?
https://www.amazon.com/gp/aw/d/B000...?colid=FO5V12JKS5RP&coliid=IA2H3QX0UE0GM&vs=1
With the switch between the battery and the winch, I don't believe AFD is needed.
Thanks
Okki
One of the biggest problems we suffer by replacing the starting battery with a deep cycle, is that unless you completely charge the deep cycle battery, you'll suffer at the standard charge rate the truck is designed to deliver. You have steak battery, but a peanut butter and jelly charging system.
Charge the battery on a good quality trickle/float type charger...bring it back to good health...and let us know how it shakes out.
1 May, 2014. Is when I installed it. If it's a bad battery, hopefully the dealer test will show that tomorrow.
Too bad Sears doesn't carry the rebranded Odysseys any more, so you're going to get a crap replacement, unless they give you a refund.
Do you have the old Warn wireless controller by chance? That thing has a pretty huge constant draw if it is plugged into the winch. I threw mine out and got the new style when I noticed how much my battery cables sparked when reattaching them with the old style.
Old:
![]()
New:
![]()
I have the same battery installed about the same time you did. I started have weak start issues, as I don't drive it all that much. I started running a smart charger on it. The first cycle it took almost 9 days for the charger to read good.
[MENTION=47340]Titanpat57[/MENTION] is spot on.
I since permanently installed a NoCo Genius Gen 1 4amp and I plug the truck in whenever I know it's going to sit for a few days. Since I started doing that my battery has come back to life. The smart charger will go green in just a couple of hours after being unplugged for a few weeks. I suspect I may have done some damage to the the battery but since I have stuck with this it is acting really solid again.
you must have something grounding somewhere causing a slow drain. perform a drain test and try to see if you can figure out where its coming from.
Hi cvc7chris,
Okki found his problem; he's got POS (+) and NEG (-) cells interacting within the casing of the battery itself, causing his current storage reserve to be depleted. The truck's electrical system should be fine now!
Cheers
Sure! It's mounted on the same piece of aluminum my lights are. It sits right behind the grill (it is IP68 rated). Lol you can see the charge status through the Toyota emblem.Nice, amazon has them for a 100 bucks.
Where do you have yours lines mounted, can you share a photo? Any additional information will be helpful to me and others.
I do not use sears batteries . internal failures . cell structure is weak breaks.
also on the sears deep cycle battery my family member purchased one and it died with in 2 yrs . battery had open circuit under light load . never abused.
The battery he has is a re-branded Odyssey battery, not a "sears" battery, which is made by other manufacturers, not sears directly.