oljedi11950
New member
Those pics are *****in' !!!
Intruder's build and off road pics thread
- Thread starter Intruder
- Start date
KVA
Member
hoto:
Engineer
New member
Should we do this today as well?
What semi is running around without an axle! Kidding but what did that start its life as?
2014 Warthog
New member
So... are you going to be changing your sig soon then? 
That's a custom housing w/ a Toyota 3rd, I believe (looks like Low-Range offroad?) I too would like to hear more details and looking forward to seeing the SFA 5th Gen!
Last edited:
SilverKast
New member
What the heck? How have I missed this thread?
I have a lifted 4Runner as well as an 80 series Cruiser that would be great fun to take out on these types of runs...
And I'm also in Calgary! And enjoy Nikons too
I have a lifted 4Runner as well as an 80 series Cruiser that would be great fun to take out on these types of runs...
And I'm also in Calgary! And enjoy Nikons too
Intruder
New member
Sorry, it's an axle for a 1st gen Tacoma that was sitting in the shop. I'm a fisherman and I was just casting out some bait. Sorry Ben...
bimrunner
New member
Sorry, it's an axle for a 1st gen Tacoma that was sitting in the shop. I'm a fisherman and I was just casting out some bait. Sorry Ben...
I was seriously trying to figure out where the upper shock mounts were going... Lol! Good one! I'm coming to the conclusion that I may just keep building my 80 and hope/wait for a strong and reliable/good IFS setup for the 4runner to get more travel and beefier on the axle, boot and tie rods. The more I dig, the more it seems like it needs to be really well planned. So many darn electronics and integrated systems to just do a hack and weld... Looking forward to seeing the Taco!
Sorry, it's an axle for a 1st gen Tacoma that was sitting in the shop. I'm a fisherman and I was just casting out some bait. Sorry Ben...
That was just wrong.:fishing:
Intruder
New member
Well, I ordered early on but not in the initial run so I had to wait a while in fab line and then UPS lost the bumper for a while. A couple months later they found it and I only just had time to have it installed.
Custom made 1st gen Taco axle. Not sure where from, it was sitting there and I felt it would be funny to post a pic of it. I'm evil like that.
No. Still just a mall crawler. 4Runners are only good for mild trails I hear.So... are you going to be changing your sig soon then?
Check out the link in my sig if you want to get out wheeling with some locals.What the heck? How have I missed this thread?
I have a lifted 4Runner as well as an 80 series Cruiser that would be great fun to take out on these types of runs...
And I'm also in Calgary! And enjoy Nikons too
I know. I'm a bad person.
Engineer
New member
Sorry, it's an axle for a 1st gen Tacoma that was sitting in the shop. I'm a fisherman and I was just casting out some bait. Sorry Ben...
:ban:
Similar threads
