Limited Fender Flare / Cladding Removal and Re-Install

I have spent an unreasonable amount of time searching for the correct clips, and have ordered three different types that I thought may be a replacement for the originals. Nothing worked. I attached a picture of the original two piece clips (obviously broken but you get the idea). 98 limited 4wd auto. Has anyone found a suitable replacement for these? I'm about two beers away from gorilla gluing the F(&*^$ thing straight onto the fender.

edit: forgot to mention...drivers side rear quarter panel flare...the one that is circled in the picture
 

Attachments

  • IMG_0532.jpg
    IMG_0532.jpg
    142 KB · Views: 658
  • IMG_0531.jpg
    IMG_0531.jpg
    142.4 KB · Views: 650
  • IMG_0542.jpg
    IMG_0542.jpg
    136.7 KB · Views: 650
Last edited:
can anyone think of a good way to restore the cladding to its original color? obviously you could just pull them off and paint them using the instructions in this thread, but i think i could live with the color as they came, just want to remove the faded look.

would my best bet be to just pull them off and paint them? if i were to paint them the original factory color, is there a color code for it anywhere?
 
Driver side door cladding was removed by a car wash and I don’t have the privilege of being able to see which clips (red or blue) go in each square hole. Can someone tell me which clips go in which holes on the driver door? Mine is a 2000 if it matters. I have searched everywhere with no luck!
 

Members online

Forum statistics

Threads
278,316
Messages
3,554,111
Members
248,016
Latest member
Advally Service

Trending content

Back
Top