My 98 Limited

Here's what parts I used:

GENUINE TOYOTA Tacoma hood
GENUINE TOYOTA Tacoma hood mounts
GENUINE TOYOTA Tacoma fenders
GENUINE TOYOTA 4runner Limited flares
GENUINE TOYOTA Tacoma radiator core support
GENUINE TOYOTA Tacoma hood latch
AFTERMARKET CLEAR Tacoma marker lamps
GENUINE TOYOTA Tacoma headlamps
AFTERMARKET BLACK Tacoma grille
GENUINE TOYOTA 4runner bumper
 
I did the flares. I had two extra fenders that were busted up from the junkyard. Cut the bottom half off to used as mock up. Then placed against the Tacoma fenders for template. Cut holes for clips and there is the end result.
 
Did this today

Before
ahuruhah.jpg




After
gese8eny.jpg
 
Installed a fog light stalk from the same Lexus ES300. Didn't wire it up yet for the fog lights.
2uqeveta.jpg




Also my cheap phone accessory charger died so I replaced the whole lighter with a Blue Seas USB charger
bybaduzu.jpg



apesyvap.jpg
 
When I bought my runner it had some flaws. This was 1 of the major. The PO put duck tape over the ripping leather.
6e7asa2u.jpg


I found this at the junkyard today
5y3egyhy.jpg


Look what was on the side of the chair
ma7ytabe.jpg
 
Even though it's hot in WA right now, I tested out the seat heater and it worked great. Not bad for 40 bucks. Even though it's only the drivers seat, it's Ok. My wife and son wants 1 on the passenger side now.
 
Changed to Black grille again & Black chrome Lexus badge from the ES300
6ymuzyru.jpg


Also changed the rear badges to Lexus also from the ES300
usujapy4.jpg


Old sombrero off & new Lexus on
abu5epyt.jpg


In the 2nd picture above you can't see the Black chrome LEXUS badge on the lower right, but here's a close up
a8ajytyh.jpg
 

Members online

Forum statistics

Threads
278,312
Messages
3,554,089
Members
248,016
Latest member
Advally Service

Trending content

Back
Top