Jetboy
New member
Should I be suspicious there is a pause before he attempts to get out?
No. There are tons of videos of heavier LC200's in soft desert sand doing the same thing.
Should I be suspicious there is a pause before he attempts to get out?
In order to accelerate in the snow or on extremely slick surfaces you need to be on the edge of traction. You know that area between going forward and spinning? Yeah, there. In order to be at that point ATRAC will be DETRIMENTAL to your forward progress instead of helping go forward. That's why Toyota thoughtfully included a "VSC OFF" button. This way if you are stationary on a slick hill and you need to move forward you can turn VSC off and allow your tires to break traction and spin in order to get on that "edge" of traction. ATRAC or VSC in that situation will brake your wheels or retard your throttle and keep you stuck!
Very helpful explanation. I got myself into a pickle this past weekend and we tried ATRAC to no avail. Steep, narrow, muddy hill climb that I was the last one up. Had decent mo, but when I started to spin, I let off the gas (mistake) because of my inexperience and stares from 4 or 5 Tread Lightly trainers (one of which owned the property). Situation was tough. Backing up more than 3 feet would have cause the vehicle to slip and rest against some trees (no thanks). I tried a few more times doing some two peddle driving getting the RPMs up to 1500 (sweet spot imo). We were hoping we could be a 2nd gear start, but it doesn't seem to be able to do that. Kept slipping. Someone suggested ATRAC and gave an explanation that we would hear the ABS working. In retrospect I think that person was confusing ATRAC with crawl control. I realized that engaging ATRAC would require me to drive with one foot so as not to override it. Well... It didn't make a hill of beans worth of difference. Got the car up to 2100 - 2500 RPMs but I never got enough momentum to do anything. Your explanation of VSC would have been helpful to know.
So how did I get out? We checked the tire pressure and what was 18 psi at 7:45 am was 20+ that afternoon. I dropped to 12 psi and hammered the skinny peddle. Crawled out of there like a champ.
This is by far one of the more civilized threads. When 15 people answer a certain question the same way then the problem is usually not with the 15 people, it's with the one asking the question.
1500 engine RPM has nothing to do with it. You were in one very specific situation and you were immobile. Listen:
The wheel sensors are set up to detect a delta between the wheels, just like VSA. When you have all wheels in the snow who knows WHAT wheel will be the one with traction. So in essence a wheel needs to spin at a differential RPM from the other wheels before the processor will analyze the signal and determine the best course of action for that specific wheel. Now, it has to also determine that this differential RPM is NOT caused by common everyday occurrences like: Sharp turns, worn tires, low air pressure in one tire, etc. You see, all these things will cause a differential RPM between wheels too so the differential between wheels has to be GREATER than it would be in everyday driving. In addition to this, you need to note that ATRAC works at other speeds besides "stuck" which is the ONLY condition you tested. So, while in your specific case the speed the ATRAC actuated "felt" excessive, if you were traveling 15 mph then the ATRAC would be performing it's task of braking spinning wheels without any discernible trigger.
In order to accelerate in the snow or on extremely slick surfaces you need to be on the edge of traction. You know that area between going forward and spinning? Yeah, there. In order to be at that point ATRAC will be DETRIMENTAL to your forward progress instead of helping go forward. That's why Toyota thoughtfully included a "VSC OFF" button. This way if you are stationary on a slick hill and you need to move forward you can turn VSC off and allow your tires to break traction and spin in order to get on that "edge" of traction. ATRAC or VSC in that situation will brake your wheels or retard your throttle and keep you stuck!
Now, if you would have read these very good responses from a lot of good people who took time from their weekend to try to help you understand, then you would have come to the same conclusion as I outlined above. Instead you came here looking for a specific answer to fit your one test. In snow, ATRAC or VSC is not going to help, unless you already are at speed.

Not sure if this photo would help any but atrac works really well in soft sand/dunes. I was going up very loose sandy hill with a slight incline in 2wd and the rig started sliding. The incline was not much but was there and of course photos dont really portray it well. Came to a complete stop and then dug myself in pretty good. Atrac flipped on and eventually did its job. IMO its pretty darn impressive.
![]()
You were right - almost 3 years later, I'm getting good info to keep in mind when I finally take my new TRDOR off road and into snow. Thanks, all!This is actually going to be a really good thread for future people who and learn about atrac. Sorry if I was a little abrasive with my comments OP. This a 4runner forum, not Lexus so we are not always as civilized. I do like me some grey poupon though.