jacksparrow
New member
A few may argue but im still loving my Toytec lift
.
What sliiders are those?
Post your LIFTED pix here!
- Thread starter B'klyn_Mike
- Start date
What sliiders are those?
DeepSea
New member
Love em! Wheels took 3 attempts at buying over the course of 6 months as they sell out in less than 5 minutes. SCS is killing it evidently
Supa LA
New member
Yea, that's what I've gathered lol. Apparently you need to get a little lucky when you go to order.
Sent from my VS987 using Tapatalk
jacksparrow
New member
Thanks! I'll look them up.
Cuse Runner
New member
Looking good! What lift do you have and size tires?
Bilstein 6112, icon rear springs, toytec remote resi rear shocks
285 70 r17 duratrac tires
Supa LA
New member
Any trimming or cutting required to make that work? Are those SCS wheels?
Sent from my VS987 using Tapatalk
Minor trimming of some plastic. I had 35's with 2" lift on my last tacoma so this was pretty minor in comparison.
2" springs
Wow you think it's been a while since YOU have been on!? ha... I finally got back on here! Actually starting to mach up my setup now, and look for the shop to do it in town. Still looking to probably go the same route.
Yo Snorola truck looks great man. So what perch you on with that 6112 then? And our you rolling stock UCA's or no?
mosstache
New member
285/75/17 Grapplers
I know this post is a few years old, but if you're still on here can you give an update to this set-up? I'm looking to do the same but a little weary of the mpg hit. Those tires are about 15lb heavier than mine.
Incredible looking vehicle. You must be proud!
I know this post is a few years old, but if you're still on here can you give an update to this set-up? I'm looking to do the same but a little weary of the mpg hit. Those tires are about 15lb heavier than mine.
Incredible looking vehicle. You must be proud!
HelloBeautiful
New member
I'm running the Nitto Ridge Grapplers in 285/75/17. I had to do BMC to avoid rubbing issues and the gas mileage took a hit for sure. On a good day, I'm getting about 15.4 mpg :ybrick:
They are on the 5th perch highest setting about 3" of lift, stock UCA's :wow:
Got the lift installed and aligned at Cochrane Toyota up here, they lift a lot of tacomas/4runners with stock UCA's so are really good at aligning them after. I just wanted a maintenance free setup since its my wifes daily driver, my last tacoma I had to rebuild the coil overs 2x and the replace UCA bushings which meant downtime.
Had this setup for well over a year now and no issues.
Itlog
New member
My lift was done a year ago. Installed by me and the wife (she was the eyes for the cables and abs lines). It took 10 hours, i use the Kings non KDSS removal at the front. It was straightforward .However the back was a pain,it took 2 hours to reattached the KDSS bracket! My only experienced installing the OME lift was from my Taco. And i all learn it from the internet by reading till i was blue in the face for a year.
ps,
fake volks:becky:
ps,
fake volks:becky:
Attachments
Last edited:
Hey man lookin good, hows your experience been so far with those JBA UCA's?
Finally get to post here. Ironman Foam Cell Pros, JBA UCAs, Toytec rear bump stop extensions and Icon 2" rear springs.
Sent from my Pixel XL using Tapatalk
