Titanpat57
Senior Member
Talked to ARB rep in Vermont last weekend, and he said December for the snorkel...said the bumper is very, very close
I was told April '16 yesterday. Take it with a grain of salt.
Hope April is BS and we are getting them just before Christmas. If not I say we all mail ARB a lump of coal lol!
It only takes a tiny amount of water like a few drops to destroy the lubrication properties of gear oil. I'm not sure if Toyota running gear is vented at all, if they are then Snorkel or not its a bad idea to submerse the running gear in water. Unless of course you are trying to escape a flash flood.
I had a very small amount leak into my bike transmission from washing. it entered thru a bad seal at a speedometer cable entrance. The bearing races were totally shot from the lubrication failure.
And just to clarify... the low one in the rear is a one way valve that does not let air in. The reason people route it higher and convert to a two-way is that the quick cooling when dropping the diff into water can cause a strong enough vacuum to overcome the seals and suck water in....Front differential breather is located higher in the engine compartment. The rear is relatively low that is why most us relocate it higher.
Confirmed, it's march or april of 2016.
I may be getting a prototype installed because my truck will be being used in a series of commercials. But it's looking like summer of next year or spring.
When are you getting the prototype? I'd like to see some pictures mounted. The new one for the Tacoma looks huge.
Overland Journal posted their 2016 tacoma already decked with HUGE snorkel and bumper.... they said the 4runner bumper most likely will be next year
That snorkel is no bueno!
Hmm, I don't hate the new Taco quite as much now.
Confirmed, it's march or april of 2016.
I may be getting a prototype installed because my truck will be being used in a series of commercials. But it's looking like summer of next year or spring.