Satoshi Grille Builder?

[robaroni]

I highly recommend the Mytoy4 Satoshi Grille method. No need for bondo. Very easy.

http://www.toyota-4runner.org/4th-gen-t4rs/126906-mytoy4-satoshi-grille-mod.html

 

[AZ4runner08]

Mine is a sport 08....

 

[wkeryder4]

I could probably make another similar to this if there is any interest.

 

[flyfisher4822]

I bought my screen from these guys here and the shipping and packaging was amazing.. ill be doing my satoshi grill today and tomorrow.. currently at work now though..

How did the insert work out? How was the fit? What did you have to do to install it? Did you need the neoprene edging? Use clips, or wire, or glue gun
or. . .?

Pictures?

Thanks!

 

[SuperSavage]

How did the insert work out? How was the fit? What did you have to do to install it? Did you need the neoprene edging? Use clips, or wire, or glue gun
or. . .?

Pictures?

Thanks!

sorry been busy trying to buy our first house and this job is tiring lol as far as clips or glue or wire I did not use any of these methods. I'm no car guru nor am I close to basic knowledge of a car or truck for that matter. I molded the screen to the grille by hand by precutting (weak fake wood that starts with a "P") can't remember the name of it lol then mock fitted the screen into the grille itself and it took a lot of tweaking and stretching and Copenhagen and ShockTop but finally got it set in there I predrilled 30 holes and used 1/4 inch self short tappers which worked amazingly. Then I spray painted them black and once I got it all snug I pushed the screen out from the back molding it to give it the rounded look to make it flow wih the rounded nose.. pain in the ass but ill post a couple pix for you.

 

[SuperSavage]

Well, tinypic isn't uploading atm so I'll post some later or shoot me a pm and i'll try there

 

[SuperSavage]

 

[rsingh0405]

I think you flipped your rig, don't think its too comfortable driving on the roof

 

[flyfisher4822]

sorry been busy trying to buy our first house and this job is tiring lol as far as clips or glue or wire I did not use any of these methods. I'm no car guru nor am I close to basic knowledge of a car or truck for that matter. I molded the screen to the grille by hand by precutting (weak fake wood that starts with a "P") can't remember the name of it lol then mock fitted the screen into the grille itself and it took a lot of tweaking and stretching and Copenhagen and ShockTop but finally got it set in there I predrilled 30 holes and used 1/4 inch self short tappers which worked amazingly. Then I spray painted them black and once I got it all snug I pushed the screen out from the back molding it to give it the rounded look to make it flow wih the rounded nose.. pain in the ass but ill post a couple pix for you.

Thanks for sharing. Helpful! I like the look.