piecesparts
New member
The disconnect for the wiring on the ABS is an interesting thought. Where is that discussed in depth?
I put a set of studded Hakka LT2's on a couple weeks ago, so far I'm thoroughly impressed. In AWD it honestly feels like driving on dry pavement. I went with 235/85/16 as they are skinnier, yet within a rounding error of the diameter of my summer 265/75/16's. I'll be using them for multiple spares on some adventures this summer.
They weren't cheap, but since I'll be running them ~6 months of the year I decided quality was more important than saving a few bucks.
As for tread life, it is my understanding that the temperature plays a bigger role than whether the roads are dry or snow covered.
Guys, thanks so much for all the info/discussion on the tires. I was originally going to go with the General Altimax, but now I'm considering the Blizzaks. I originally wanted a simple, budget friendly snow tire because I'm really confident in my ability to drive in the snow and figured ANY dedicated snow tire would be light years ahead of the General Grabber HTS's I've had on the past 3 winters.
And for the obvious answers regarding my driving, yes, I engage 4WD when the weather dictates it, and I take it easy on the roads. I know how to properly apply a soft brake. There were times last winter I was going 5mph or less, and would BARELY apply brake pressure and next thing I know the ABS are activated and I start going faster. Really scary stuff.
My 4Runner is auto, but I'd engine brake/keep it in 2nd gear a lot of time when I was going 20mph or less because that way the ABS would activate minimally.
I'm 1/2 tempted to keep these tires on for the 1st snowfall and take a video showing how I need to change my underwear while trying to brake going less than 10mph.
I'll update once I get tires and I'll follow up during the winter. I'm assuming it'll be fine because even with the crappy General HTS's with 30k on them, I did ok the 1st 2 years.
Thanks again for the tire recommendations!
I've never had any problems with the ABS on my '97. Snow, ice, whatever. I think it works just fine.
One of the most common things I've seen is brake system neglect, which causes problems. Which are then blamed on the ABS system, etc.
Most cars on the road never have the brake fluid flushed. So as the brake fluid gradually becomes contaminated, the brake system becomes less effective, and if enough water is absorbed, parts can corrode and cease to work properly.
My advice is flush the brake fluid every three years or as needed.
I hear you, I grew up in CO and have experience in the snow, and have found the 4runner at times to be worse than my old front wheel drive pontiac grand am. Tires definitely make a big difference, but disabling the ABS also makes a big difference. I find it kicking in on wet when it isn't necessary, on gravel, dirt roads, all kids of places and situations where it really isn't needed. It sometimes kicks in on dry pavement during tight turning like pulling into a parking lot.
My theory is that Toyota basically went cheap on the 4runner ABS and doesn't really have an algorithm for when to set off the ABS or to which wheels to set it off. So basically as far as I can tell, if any 1 wheel slips, ABS kicks in on all 4 wheels. Modern traction control and ABS individually brake each wheel and decide on a braking strategy based on which/how many wheels are slipping.
I disabled my ABS using the (IIRC) grey wire method, taking advantage of my e-locker ECU. If you have an e-locker, then I highly recommend this mod. You can buy a $10 toyota switch that will look 100% stock, install it in about 10 minutes, and you have on-the-fly ABS disable. If you don't have the e-locker, then I still highly recommend wiring in a switch to disable it when needed. Come winter, I will leave ABS off entirely
Nelson,
I would like to disable the ABS for winter.. Can you please tell me what toyota switch to buy and a possible link to the wiring diagram. I have no e-locker. Much appreciated!
Doing this tomorrow. Bought a Toyota fog light switch off eBay for 15.00I would also be interested in any input as to if this will work on a Toy that does not have an E-Locker and where the diagram is for the mod.
So, If I read the attached forum post right, all you are really doing is connecting a switched ground wire to the "Yellow/Blue" wire on the E-Locker plug. This is all that is needed to disable the ABS function for the really bad snow days.