jbmccul
New member
No, no tape deck
What did you do with your 4runner today?
- Thread starter NorthGa4R
- Start date
No, no tape deck
emelianenkov
New member
Oh ok
Cali4Runnea
New member
Hubs installed (I helped where I could) my new rear after market spoiler! It's not perfect, doesn't completly seal to the hatch at the top, but it's not noticeable if you're not looking for it. You can see in the picture that it sticks out a little, there is foam on both sides of the spoiler where it attaches. We tried taking it off, but it seemed like it was suppose to be there, but being installed, it doesn't look right, I donno.
Before:
After (sorry for the crummy pic, just took it and it's like 30 freakin degrees outside):
Before:
After (sorry for the crummy pic, just took it and it's like 30 freakin degrees outside):
Mytoy4
New member
Hubs installed (I helped where I could) my new rear after market spoiler! It's not perfect, doesn't completly seal to the hatch at the top, but it's not noticeable if you're not looking for it. You can see in the picture that it sticks out a little, there is foam on both sides of the spoiler where it attaches. We tried taking it off, but it seemed like it was suppose to be there, but being installed, it doesn't look right, I donno.
Before:
After (sorry for the crummy pic, just took it and it's like 30 freakin degrees outside):
Love it!
Dawg4Runner
New member
We tried taking it off, but it seemed like it was suppose to be there, but being installed, it doesn't look right, I donno.
The spoiler looks good. You're right, that white foam doesn't look right. If it needs to be there then you can always replace it with black foam. Or you can remove the spoiler, cut the foam back so its not so close to the edge and color it in with a black Sharpie.
97BlackAckCL
Elite Member
I had a factory wing on my 03 sport, and it sat flush, didn't have any foam.
Looks great either way
Looks great either way
Cali4Runnea
New member
Ya the foam looks odd, although it is actually black, not white, don't know why it showed up that way in the picture, probably because I had to lighten it up because the pic was dark.,I'm going to call the company today and make sure its suppose to be there, if its not we'll remove it.
Thanks for the comments everyone! I plan to get some full body shots today to show off the finished product.
LTDSC
New member
i think its more because its new so you notice it more.
Cali4Runnea
New member
Quite possible too, sure I won't notice it all after a week, just wish it was more flush with the car.
plasti dip might be your answer. You can spray while on the truck, then peel off the excess. I would get charcoal perhaps to match your paint.
Either that, or paint your truck white. :hatsoff:
fedrlbiker
New member
Bought all the cables and an Everstart Marine Deep Cycle battery for my dual battery install. Assuming the Surepower separator and misc pieces I ordered on Amazon show up, I should install it this weekend.
Also bought Gaterose's 30" LED light bar that is going behind my satoshi grill with a piece of smoked plexiglass in front of it for stealth.
Also bought Gaterose's 30" LED light bar that is going behind my satoshi grill with a piece of smoked plexiglass in front of it for stealth.
emelianenkov
New member
Good save! I would have smacked her cause my brakes are terrible. Need to wait til mom or tues for all my parts to show up
emelianenkov
New member
That's awesome. I'd have my horns blaring, but only one works now (*ahem* "flood damage") so it sounds wimpy. Just another thing on the list to replace.. :moping:
emelianenkov
New member
:girl:
In progress I hope!
Similar threads
