Put on some spacers. 1.5" in the rear, 1.25" in the front. Allpro spacers. 275/70/18 KO2s on 2/3 Toytec lift. The tires rub terribly on the front bumper now after the spacer install. Will need to get some dremel bits and grind some off.
Thanks! I got them from Tiregraficx. I haven't seen anybody with them yet and I like the way they pop!
Installation is kind of a pain though. I have only the driver side done. Hopefully work on the other side tonight.
Installed a USB charger today that has a digital display in that square. Shows vehicle voltage when running. I was going to go with a dual but I wanted at least 2 amps charging. I noticed that all the duals were 2amps total, splitting it to 1amp each.
Problem: the rubber bottom of the original 2005 cargo mat with the 4Runner logo had deteriorated to the point that it would continually release small particles that had to be vacuumed, so I got rid of it.
Use case: light duty - keep things from sliding around in the trunk. (I always keep the double decker in the down position.)
3mm 68" by 24" yoga mat from Walmart:
Cut in two 34" halves, then trim each half to required 20.75" width. Cut resulting strips to 20.75" length. Put everything together with duct tape like so:
