What did you do with your 4runner today?

[plutonic]

Installed the organizer kit.

Drove it to New York and carefully applied some snow on top of it.

 

[momo.75]

Installed the organizer kit.

Drove it to New York and carefully applied some snow on top of it.

Where did you find the organizing kit?

 

[YetiX]

Couldn't be happier with the look and the ride. The sun was setting pretty quick so these were the only shots i was able to get today

Damn Morris, those look sexy AF!!!

what plug is that for the wiring connector???

It's a standard 7 pin trailer harness. Doesn't everyone have that??

 

[xcmountain80]

4R planned out a Projector upgrade.........yes


Sent from my iPhone using Tapatalk

 

[rokr1292]

I installed a Volant intake today, only to find that my T4R no longer stays running. It starts, but then dies in a few seconds with no codes. thought it was the MAF, cleaned it with no success, and went as far as to test with a replacement too, no success. I thought maybe I jogged the SAIP bypass loose, but I dont think so. Next is recleaning the throttle body, but it's real cold today and my hands already hate me.

 

[momo.75]

Damn Morris, those look sexy AF!!!

Thanks man!...:yo:

 

[Primetime4370]

Where did you find the organizing kit?

They are available on Amazon. Also, the vendor is on here. OCD organizers .

 

[riceandpho]

realigned my lights, just had to do a slight horizontal adjustment on the passenger side, apparently I had it a little too wide, too about 4 to 5 inches to much to the right.
also played with the techstream software, V10.30.029 works well for me, the newer one just dont work quite right.

adjust the light turn off right away, so it just turn off my lights if I leave the stalk "on" and key out and door open.

too bad I can't custom the windows to roll with key since I don't have a limited.

 

[bagelsjustbagels]

It's a standard 7 pin trailer harness. Doesn't everyone have that??

Yes but i mean plugging in the license plate lights into the 7 pin harness

 

[djkurious]

Changed passenger side wheel bearing hub @257k. Drivers side was replaced @247k exactly one year later on the same date!

 

[JVC8790]

They are available on Amazon. Also, the vendor is on here. OCD organizers .

I just ordered the same pair yesterday, should be here next week!

Today I put in the Pioneer AVH-200 that I took out of my Volvo before I sold it.

Then took it out in the snow for a little bit!

 

[kosal]

installed rear view camera

Installed rear view camera so can easily see my hitch when backing up to trailer.

 

[Miller89]

I saw a sticky on a FJC forum. I thought I would start this one for the runners..

I should have been blowing leaves, but I found out what plasti dip is...

View attachment 53122

Who else did something neat today?

-Henry

Put my 4runner up for sale!:lmao:

 

[YetiX]

Yes but i mean plugging in the license plate lights into the 7 pin harness

Still not sure what you're asking so . . . the license plate light/bracket did not come with a connector, just the wires. I bought a round 7 pin connector at O'Reilly's opened it up (there's a small set screw), connected the wires to the right connectors using a diagram I found on-line, sealed the connector back up and done. I got the wiring wrong the first time because I transposed the diagram.

 

[Primetime4370]

This today..

[/IMG]

This last weekend..

 

[JVC8790]

Looks good! Are you planning to do the door trim to match?

I've got some gloss black, matte black, and brushed aluminum Vinyl I was looking at using for this trim and the door trim as well.

 

[kingofthehill]

Just received a call from the crooked salesman I bought my 4runner from at my local Toyota dealer. He seems to call every six months and I always miss his calls. Today I saw a call and not knowing it was him (just got new phone) I answered it. :redbrick:I am still angry about how he tried screwing me out of $600 when I bought my 4runner.

https://www.toyota-4runner.org/2757903-post7613.html

 

[Primetime4370]

Looks good! Are you planning to do the door trim to match?

I've got some gloss black, matte black, and brushed aluminum Vinyl I was looking at using for this trim and the door trim as well.

Yes I plan on doing a few more pieces and the silver parts on all 4 doors.

 

[BendRunner]

ARB Single installed! happy to have on board air now!

 

[AuSeeker]

ARB Single installed! happy to have on board air now!

Where did you get the OEM style compressor switch?