wtb:Roof rack cross bars

[DIVNWND]

So i purchased a 99 4runner and it is missing the cross bars on the roof rack. Any one have any they would sell would be awsome. I have the rails on it that run the length of the vehicle but need the horizontal cross bars.

 

[rdgt4r]

I have them, but I did drill 3 holes (2 on one bar and 1 on the other) for my bike mount. I have yakima bars now so the factory ones just chill in the garage. Let me know what you think?

 

[DIVNWND]

I'm interested how much you want for them. not to concerned about holes i want to put a ski rack on it so all should be good. Do those just slide into the rails or do i need something else?

 

[rdgt4r]

PM'd

 

[manhunter]

I'm interested how much you want for them. not to concerned about holes i want to put a ski rack on it so all should be good. Do those just slide into the rails or do i need something else?

If his don't work, I have the cross rails, hardware, racks, and everything for sale.

 

[Snwwlkr7]

If the above doesn't pan out I've got a set, crossbars only off of my 97 I would sell also. I bought the Yakima bars too.

 

[Jeffkin]

Help!

OK, I know this is a dumb question, but I need help. I can't figure out how to put my crossbars ON!? I just bought a '98 and the guy has factory Toyota Ski racks on his crossbars, which is great! BUT he had the whole assemblies completely off when I bought it. SO how do I put them back on, without snapping the little plastic tabs off of them? It doesn't look like the ends are supposed to come off the rails, so how do I slip them on?! He did give me the knobs to tighten them down with, but I need to get them in the rails first! HELP, I leave for Tahoe tomorrow! Any tips GREATLY appreciated!!

 

[manhunter]

OK, I know this is a dumb question, but I need help. I can't figure out how to put my crossbars ON!? I just bought a '98 and the guy has factory Toyota Ski racks on his crossbars, which is great! BUT he had the whole assemblies completely off when I bought it. SO how do I put them back on, without snapping the little plastic tabs off of them? It doesn't look like the ends are supposed to come off the rails, so how do I slip them on?! He did give me the knobs to tighten them down with, but I need to get them in the rails first! HELP, I leave for Tahoe tomorrow! Any tips GREATLY appreciated!!

On the rear of the rail, there is an end-cap that comes off with a star shaped screw-driver. Remove that on both sides, then slide them off via the back of the rail.

 

[Snwwlkr7]

On the rear of the rail, there is an end-cap that comes off with a star shaped screw-driver. Remove that on both sides, then slide them off via the back of the rail.

I'll add to manhunter's advice..

Getting the end cap back on was a little difficult on mine. I had to also loosen the next closest star screw on the rail so I could slightly lift the rail to get the end cap back on.