ZUK mod? Yes? or No?

[ToyoTech]

Looks great. I would leave it!!


Sent from my iPad using Tapatalk

 

[levi.watson]

Looks good! I'm curious, when you say that the ride improves, what improves about it?

Also, when putting the spring in, how did you compress it?

 

[joeynational]

Thx guys!

Well if your hitting your bump stops this will keep you off of them. If you've never hit a rear bump stop its very uncomfortable. The ride is not stiff like i thought it would be. I rented a spring compressor from autozone along with putting a bottle jack between the leaf springs and frame to spread it open a little more. For $30 i can't complain

Sent from my LG-D801 using Tapatalk

 

[Dubk_trd]

new lift

Followed Joeynational and got me some moog 81043 off amazon. Raised it up pretty high straight from the box. I cut off about 1 1/2 coil off and were sitting pretty good.

 

[89FourRunner]

Looks good. Does not seem silly high. As long as the front fenders appear slightly higher than the rear fenders it is fine.

 

[RAD4Runner]

...Moog springs from Walmart of all places for $30....

Followed Joeynational and got me some moog 81043 off amazon. Raised it up pretty high straight from the box. I cut off about 1 1/2 coil off and were sitting pretty good.

Thanks, guys!

Is it $30 EACH or for the pair?
Is it the one with bigger ID on one end and smaller ID on the other?
Websites say pics are "not actual image of actual parts"

I'd like my rear to be a little bit higher like how Joey National's look s^^^.
Have they settled at all? What are you measurements now? May I ask for rim to lip of wheel-well measurement so it is independent of tire size?

 

[joeynational]

Thanks, guys!

Is it $30 EACH or for the pair?
Is it the one with bigger ID on one end and smaller ID on the other?
Websites say pics are "not actual image of actual parts"

I'd like my rear to be a little bit higher like how Joey National's look s^^^.
Have they settled at all? What are you measurements now? May I ask for rim to lip of wheel-well measurement so it is independent of tire size?

$30 for the pair

Yes to smaller and bigger ends

I paired mine with a "1.5 ball joint spacer in the front and was about perfect. Since then it has settled some but i have not measured. But you can tell the front is slightly higher. I will adjust my torsions to compensate. I can get you some measurements tomorrow