2008 T4R Limited V8 AWD Rear ABS Sensor Wiring Harness

[lemii]

I'm a knit wit, one of the first things I noted in my own bearing replacement guide was to remove the ABS sensor BEFORE removing the axle shaft. Well, I skipped that step because I thought I could go by memory. Anyway, when I pulled the axle out, I broke the two small wires going to it. I was able to solder them but I'm concerned they may cause an issue. I'm having a hard time finding the right replacement wiring harness, I see some for the left hand side, rear, and some for center, but I've not come across one for the right hand (passenger) -side rear. I see some harnesses that seem to have one main connector and two lines, one going to one side and another to the other. So, any leads on what I need to get to replace the wiring for the right hand rear ABS sensor?
Thanks.

 

[Jason B]

This help?

Thread 'Broken ABS Speed Sensor Harness Fix'

May 30, 2013

I know its a common problem for people to break their harnesses when they do leveling kits or lift and so forth, so I thought I share what I did when I broke mine. I installed a 3" leveling kit right after I first got the car. I didn't realize how sensitive the wire harness was when I did the install. After I finished the install, I turned the car on and saw all the lights on my dash and kinda freaked out. So I did a little research and found out the cause of the lights and came to the conclusion that I busted my harness. I pulled off the old harness and checked it for continuity with a...

• tjhaf2007
• Replies: 21
• Forum: 4th Gen T4Rs

 

[lemii]

Thanks for the reply. I kind of did the same thing, only I used shrink wrap on the wires. It was a bit difficult because the wire broke very close to the connector, but I think all is well as I've no lights coming on!