jrob
New member
Quick update. The install is going smooth and everything is very simple so far. I should have my ECU back Friday, or Monday....
I did however run into something that slowed me down. Probably just me being anal.... But I scoped my lower intake runners and they are nasty and full of grime. So, I stopped and think I'm going to pull that and clean it out thoroughly. Here is a pic of the top of the motor with the plastic intake removed... The actual intake is what I'm going to pull next that is not necessary for the install.
I think I could just bolt on the blower and be fine.. but it will bug me to know all that grime is in there...
I would be really curious to see what another one of these looked like down in there. I was a bit shocked when I saw it.. but makes sense with all the dusty conditions I've been in..... will report back after I attempt to pull it.
The actual ports into the heads looked fantastic as the injectors keep the oil mist off the sides, but the intake bakes a grime in it... I should probably just leave it alone.... but I'm that guy.
I don't think it's out of line at all man. You have it torn down, and you're going for more power anyway, so might as well get those runner cleaned up.
When I had the lower plenum pulled off my Z it looked the same. I ran it down to a local shop, and they put it in their parts washer overnight. Came back like a new penny, and they didn't charge me. Pitched them a $20 anyway.
Props on attention to detail. Stoked for your results!