Blitzkrieg
New member
Okay, those last two pics.. I don't have my 3rd gen anymore to check but that definitely does not look right to me.
The only time it ever acts up is when I put gas in it. It takes about 30 seconds of cranking before it starts, then it will stumble for a bit, sometimes stall. After it clears up I can turn it off and restart it and it's like it never had a problem.
This is also the first vehicle I have owned that I noticed wouldn't hiss after removing the cap.
Well I checked all vsv valves and they are all properly switching. Also checked hoses and couldn't find any leaks so I'm still not sure what it could be. I did find two hoses backwards on the valves under the hood so I hope that is what was turning the light on.
What's the CEL code? I've seen similar behavior from a bad evap purge solenoid on other vehicles, but I'm not familiar with our evap system.I too just started having this problem. Check engine light came on. After filling the tank I drive about 100-200 feet and then it shuts off and doesn't want to start for a minute or two and then starts and runs like nothing happened. I just drove from Atlanta to DC and in South Carolina where the roads are rough and it was very hot the car would burp and fart then shut off from time to time. Then when the roads smoothed out in North Carolina it happened maybe once or twice. then later when the sun started going down and the temperature dropped it did not happen at all. But, every time I got gas no matter the temperature it would start and run fine for 100-200 feet and then shut etc. and then run like nothing was wrong. Not sure what MPG I'm getting. Any ideas?
What's the CEL code? I've seen similar behavior from a bad evap purge solenoid on other vehicles, but I'm not familiar with our evap system.
Pretty certain this is emissions related but I have a 2001 4runner sr5 4x4 that is stock except for a k&n fipk kit, lift, and one size bigger tires.
The problem I'm having is every time I get gas and I go to start it and it won't start unless I push the pedal to the floor. Each time I fill up I am getting 14-15 mpg 95% hwy. and to clarify fill up I mean when the pump stops on the first click.
I bought this tr4 two months ago and it has been the issue since I bought, I should also mention I am getting the good ol po440, po441, po446 codes but when I search them nobody else seems to have an issue like mine. I'm hoping I don't need to replace the charcoal canister, I am looking for things to trouble shoot first and not throw parts at it. Thanks in advance
My 2002 is doing the exact same thing. When I fill up, it will stall when I put it in gear. After I get it going on the road, it runs fine. I only have this issue at the pump and I do not overfill the tank (just first click). I have taken the cap off and back on to see if I can recreate it and its like noting ever happened. I ran a DTC scan and it threw P0440 EVAP and a P0420. I cleared the codes and installed a new gas cap and the CEL has not come back on but I am still having this issue when I get gas. Has anyone found the solution?
My 2002 is doing the exact same thing. When I fill up, it will stall when I put it in gear. After I get it going on the road, it runs fine. I only have this issue at the pump and I do not overfill the tank (just first click). I have taken the cap off and back on to see if I can recreate it and its like noting ever happened. I ran a DTC scan and it threw P0440 EVAP and a P0420. I cleared the codes and installed a new gas cap and the CEL has not come back on but I am still having this issue when I get gas. Has anyone found the solution?