Pac RP4.2-TY11 vs Crux SWRTY-61J: Do you lose front to rear fading when using the Crux wiring adapter?
New 4Runner owner here. We just bought a one owner/low mileage 2007 V8 Limited with the factory JBL navigation. The factory radio/navigation system is annoying to use at best, so a new head unit is needed to keep my sanity. The JBL amps and speakers all sounded fine, so will be retained.
After visiting a few stores and reading a lot of reviews the Sony XAV-AX5000 head unit was chosen due to it's Android Auto capability, clean interface, and and ease of operation.
So I am deciding between the Pac RP4.2-TY11 and the Crux SWRTY-61J wiring adapters. The Crux is both smaller and cheaper, but some things I've read suggest front to rear fading is lost. The Crux instructions were unclear on this.
From the
Crux instruction sheet:
NOTE: Aftermarket radio rear speaker output leads are not used on both harnesses. Insulate with tape.
The above strongly suggests that the Crux does not support front to rear fading. It would be nice to hear from folks who actually installed the Crux.