ScanGauge II 3D printed mount

[SpeedyKevin]

Looks good! Almost have the same gauge layout as I do! Instead of MPG I have trans fluid pan temps.

 

[61hawk]

Got mine in the mail today. Used 3M emblem tape and 3M Dual Lock "velcro". I mounted mine up close to the steering wheel.

 

[matoolie]

Got mine yesterday. Used 3M tape. nice, secure fit.
Thanks [MENTION=244368]geofox784[/MENTION]!

 

[97BlackAckCL]

Got mine in the mail today. Used 3M emblem tape and 3M Dual Lock "velcro". I mounted mine up close to the steering wheel.

Curious how you got the tire pressures to display?

 

[SpeedyKevin]

Curious how you got the tire pressures to display?

>> Toyota TPMS Method 1


I use both the pressure and temp sensors

 

[gsla72]

Back from the dead - is the OP still producing these? I don't have access to a 3D printer. I'd be interested in buying one.

 

[geofox784]

Back from the dead - is the OP still producing these? I don't have access to a 3D printer. I'd be interested in buying one.

I am. Send me a PM with your address and paypal email.

 

[gsla72]

I am. Send me a PM with your address and paypal email.

Awesome - Thanks for the quick response! Unfortunately my account is too new to be able to send PM's... Any way you could try sending me one to start the conversation?

 

[geofox784]

Awesome - Thanks for the quick response! Unfortunately my account is too new to be able to send PM's... Any way you could try sending me one to start the conversation?

Interestingly it won't let me either. Send me an email at [email protected]

 

[gsla72]

Interestingly it won't let me either. Send me an email at [email protected]

Just sent you an email - thanks again!

 

[2707me]

I am. Send me a PM with your address and paypal email.

PM sent

 

[geofox784]

If anyone wants one of these and I didn't get back to you please let me know. I may have lost track of some of the messages between email and the forum messages. I just printed a new batch that is ready to go.

 

[Bradd D]

Very clean solution.

 

[geofox784]

FYI to anyone that finds this thread, I am still making these for anyone that wants one.