What did you do to/in your 5th Gen today?!

[Quentin]

I ordered one of these so that I could keep the miles, and baby spit-up, off/out of my 4Runner.

 

[deekoi]

Took it out to lunch and gunned it a few extra times just to listen to the aFe intake :lookout:





probably blew a good gallon or two...

 

[azn-sensation]

Finally installed my tranny cooler. Now I have peace of mind when towing my track weapon.

 

[Tallicon]

Washed her up and did my first "mod"... Put on the Baby on Board sticker so the tailgating jerks will back off! I also had some fun taking sweet shots.

 

[Mijfwb23]

Did a little plasti-dipping today.
Did the rear emblem also but it is still taped up and drying.

 

[Redwolf]

Plasti dipped the rear emblem too

 

[cbielat]

Cleaned the interior.

 

[oakjefferson]

Finished moving everything over to the 4Runner from my old Edge and programming all my XM presets.

 

[Intruder]

Had some rubbing here:

Not any more:

Here are the culprits:

And some new lighting:

 

[Antman]

I had some rubbing too...:cry2:

 

[Intruder]

Ouch. I actually backed into a Sienna on Tuesday. My rear passenger corner went into the middle of his rear hatch. Completely collapsed the hatch on the Sienna to the tune of around $4k of damage. I have a few scratches and nicks. 4Runner > Sienna.

 

[Qjake]

^^Rub on the body mount? Did you just trim it off and leave it or weld in a new piece for strength? I'm putting on 295/65r18 DuraTracs and I'm sure it'll have to be chopped just curious how you finished yours. Could you post after pics?

Thanks

Q

 

[Qjake]

I had some rubbing too...:cry2:

Ouch!! That sucks!! Now pay attention next time :bash:

 

[Intruder]

For right now it's only cut and rounded off. I'm taking it off road tomorrow so figured it'd be best to make sure there's no rubbing left at all before welding anything on and painting it.

 

[Antman]

Ouch!! That sucks!! Now pay attention next time :bash:

:rockthrow:

 

[Qjake]

Good idea, though I've seen others if you have time would like to see your finished product.

 

[Intruder]

Sure thing. We also ended up bending and hammering the pinch weld just to make sure. There wasn't any rubbing on the passenger side body mount but it looked close so we just took a grinder to it and didn't actually cut it.

 

[Qjake]

:rockthrow:

OW :lmao:

Sure thing. We also ended up bending and hammering the pinch weld just to make sure. There wasn't any rubbing on the passenger side body mount but it looked close so we just took a grinder to it and didn't actually cut it.

Good to know on the pinch weld will def look at it, thanks.

 

[mjixx]

detailed vehicle on warm chicago day and failed at attempting to lower spare tire before drive to st louis.

 

[mikey's2010SR5]

I towed a trailer with all of my belongings to my new home.

:cry2: