4Runner 2010+ Supercharged
- Thread starter Skull550
- Start date
BlackWorksInc
New member
So... wouldn't you want a Twin-Scroll set-up like the TRD/Eaton vs. the Centrifugal Set-up pictured above? I mean I understand the Centrifugal units are somewhat customizable and more affordable, but I have always read the Twin-Scrolls to be more efficient/powerful.
Taco04
Member
Wow that's a clean install I am guessing this is the Bullet Supercharger kit? Did you get it tuned yet?
http://www.bulletcars.com/superchargers/toyota/prado/dvvti-4lV6-prado.html
http://www.bulletcars.com/superchargers/toyota/prado/dvvti-4lV6-prado.html
Last edited:
wfo9
New member
Not really. The positive displacement units do tend to make boost at lower RPM, but the efficiency usually drops off pretty quickly. They can also be decent, but the centrifugal designs almost always have more HP potential. A big factor is that they can use traditional air to air style inter coolers. Postive displacement units have a lot of issues with heat soak.
The downside to the centrifugal is that they often require more RPM to make boost, but I never found it to be a problem. I have never had one on anything but a V8, so not sure how it would feel on the 1grfe. I'm sure it would feel good with the right pulley and head unit. Some do make more noise also. Often a loud whistle at low rpm.
Last edited:
Hellamatic
New member
Oh good, another supercharger thread. Makes way more sense to start a new thread rather than add this info to one of the other threads. I'll believe this when I see it.
Belaire23
New member
Its beautiful........... :shocked: :jaw:
Please dont be a farce.
MORE PICS!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!11111!1!!!!!one!!!!!!
Formidable
New member
As others have requested, we need more info.
-Will this work for 2013+ with air injection?
-Fitment? What lines need to be relocated?
-Power to the wheels before and after?
-Unichip is notorious for being a crap system. What problems have you encountered with tuning?
Price?
Formidable
New member
Please check your PM. I know you logged in yesterday. Please don't be flaky and answer the questions posed in this thread.
Last edited:
Keith_PDX
New member
Guys, give the man a chance. This thread is horribly embarrassing with the childish responses. Perhaps the person has a job and cannot monitor the forum on an hourly basis. Before jumping on the negative bandwagon lets at least give him an opportunity. No sense in pushing away a potential source for a desired product. Its premature and immature.
OP - Please post your official contact information.
OP - Please post your official contact information.
Formidable
New member
Getting him to respond is like pulling teeth... Which should not be the case on a thread like this. So have to agree with you on that.
you obviously are a noob here.... this forum is one of the most optimistic and knowledgeable groups out there
jrandom
New member
1engineer
Moderator
Not me. I just think the glass was misapplied and they should have went with a smaller glass for best efficiency.
