A.Wilson013's Build Thread

Status
Not open for further replies.
Very clean runner, looks great.




435! ... guess they thought you were born yesterday huh? Last time I was there the dude in front of me was buying 2 crappy passenger tires, an oil change and some other minor thing. It was like 465, I was like... um...

I keep missing responses...

Thanks for the compliment!

In regards to Firestone, I went for an alignment and they called me back to inform me the caliper was seized. They tried for awhile to free it up, and then sent me on my way without me spending a penny, so I wasn't too upset about the outrageous price. I did however make a sort of snide chuckle when he showed me the quote.

I plan on going back when I get my alignment though.
 
1999 4Runner SR5 Sport -
TRD SC'd 3.4, Supra 315cc Injectors, TRD Exhaust, Elocker, URD MAF FTC, ISR, Eclipse AVN5435, AEM UEGO, Plasti Dipped Toyota Logos, 265/75/16's on Tundra Wheels

This is the only picture I have of it the day after I purchased it. Christmas Day 2010. Note the tacky stickers, running boards, and CHROME Tundra wheels. Other than that it had the Supra Injectors, a Split Second ESC1, Split Second ARM1, and APEXi SAFC
IMAGE_194.jpg~original



For now, because my wife wants to go to lunch, all I am doing is posting pictures.
Interior
IMG_0056.jpg~original

IMG_0057.jpg~original


Exterior:
IMG_0106.jpg~original

IMG_0100.jpg~original

IMG_0090.jpg~original

IMG_0088.jpg~original

IMG_0083.jpg~original



Anyway, more to follow. Time for lunch.

Alex

I like your compass by the gear shift! Where did you get it, I'm looking for something like that for my rig! Is it usually pretty accurate?

ALSO: Nice rig! I really like the beginning pictures - have yet to go through and read the whole thing, I'm going to! :D
 
I like your compass by the gear shift! Where did you get it, I'm looking for something like that for my rig! Is it usually pretty accurate?

I think that's an AFR gauge, not a compass.

Sharp truck, I hadn't seen your thread before!
 
I think that's an AFR gauge, not a compass.

Sharp truck, I hadn't seen your thread before!

You're right, in that picture it is an AFR gauge. I have since replaced it with a matching trans temp gauge, and the AFR / Boost gauges in a 2 gauge pillar pod.

Also, thank you =)

Here are some photos from this past weekend!
 

Attachments

  • IMG_1263.jpg
    IMG_1263.jpg
    36.1 KB · Views: 1,692
  • IMG_1268.jpg
    IMG_1268.jpg
    36.5 KB · Views: 1,755
  • IMG_1272.jpg
    IMG_1272.jpg
    40.6 KB · Views: 1,673
  • IMG_1278.jpg
    IMG_1278.jpg
    42.6 KB · Views: 1,657
  • IMG_1280.jpg
    IMG_1280.jpg
    49.8 KB · Views: 1,701
Dude... How is your runner so clean. I mean really the roof is shiny, the roof.. I don't think there is a single spot on mine thats shiny like your rig..
 
Just a small update...

Nothing has changed since the last post, really. Alignment and some 01-02 tails from IanB.

One issue I am having is the infamous wet drivers side floor board. I ran a drain snake down my sunroof drains and hit them with some compressed air to no avail.

Not too worried about it since it won't see much rain this summer, but I'll figure it out eventually.

Other than that, just been enjoying it. Runs great, rides great, looks great... Think I'm in a sustainment phase for now. May sound deaden if I get bored next weekend.
 
Might try feeding some hydrogen peroxide down the tube and let it sit overnight. After letting that sit I blew it out with compressed air. Actually I first blew the rubber hose of the plastic drain tube between the roof and headliner.:sniper:
josh


Just a small update...

Nothing has changed since the last post, really. Alignment and some 01-02 tails from IanB.

One issue I am having is the infamous wet drivers side floor board. I ran a drain snake down my sunroof drains and hit them with some compressed air to no avail.

Not too worried about it since it won't see much rain this summer, but I'll figure it out eventually.

Other than that, just been enjoying it. Runs great, rides great, looks great... Think I'm in a sustainment phase for now. May sound deaden if I get bored next weekend.
 
thanks for the update alex, truck's looking great!

My driver's side floorboard has also been wet lately. It can't be the sunroof if you don't have one haha... the carpet got all moldy and I had to remove the underpadding. Has yours gotten that bad? I suspected the little rubber caps but sealing them didn't seem to help.
 
My buddy codyx36 told me he had the same problem and it was the grommet in the drivers side firewall. After pouring water down my windshield I believe him, and sealed it with some tape.

Also poured water down my sunroof drains and watched it spill all over the ground.

And yeah, I pulled my carpet awhile ago and shampooed and vacuumed it really well. It was quite moldy.
 
Did some driving in Oregon this weekend (meaning a lot of 55mph/1800rpm cruising, which is when my exhaust is loudest) and got tired of how loud my exhaust was while cruising.

Got home today and put some peel and seal in the cargo area. Quite the difference! Look forward to doing the rest of the cabin area.

Going to get the Trans flushed this next week in preparation for my trip on the 17th. My first real towing expedition (a fleetwood e1) from Dupont, WA to Redmond, OR. Also going to tighten up the trans kickdown cable thing to firm up the shifts for the added weight of the trailer.


Here's the peal and seal.
1812a9d0-27f8-f715.jpg


Here's my dog. She's also tired of the noise.
1812a9d0-282b-0366.jpg
 
No pictures, but this evening I took out all the seats/carpet and finished up placing the peel and seal on the floor of the cabin area. I plan to use B-Quiet sound deadening materials - B-Quiet Extreme in the doors, and if I ever start feeling antsy again, I may look for something to do the headliner with.

So far, in my opinion, the cargo area made the biggest difference. The work I did tonight didn't seem to make too big of a difference in road noise, however, my Eclipse AVN 5435 sounds the same on 40 now, as it used to on 50. I think that's pretty substantial.

As I said in my last post, I am taking a little road trip next week, so I will have more to comment after that.

Unfortunately, my trailer plans for the trip did not work out, but I kept my appt. at the dealer to get my trans flushed Friday.
 
I just sat here and read your whole thread. Yours and COB's IJM's are what my IJM dreams of being one day. So clean and excellent attention to detail.
 
dang man if this tones down the drone i just may have to do this too. cool stuff!

I'll have a bit more input on it Friday evening... Haven't driven more than ~10 miles since it has been done. So far though, like I said, I am happy.


I just sat here and read your whole thread. Yours and COB's IJM's are what my IJM dreams of being one day. So clean and excellent attention to detail.

I truly appreciate that comment, Wizzle. Unfortunately my thread is nowhere near as exciting as COB's, but I am glad you enjoyed it. One day I will try to clean it up a bit, perhaps.

Thanks again for the compliment =)
 
Had a blowout on the freeway yesterday afternoon while towing my new mattress home...

Picked up a set of 265/70/17 Toyo AT's off CL this evening for $400... Happy to be getting back into those tires!
 
Status
Not open for further replies.

Members online

Forum statistics

Threads
278,309
Messages
3,554,070
Members
248,016
Latest member
Advally Service

Trending content

Back
Top