LED Turn signal bulbs

fa73febdea6b0e0e5821941b540dadb5.jpg

Well for shitts and giggles. I changed back my front blinker bulbs to incandescent. I have blinkers again, but with a bit of hyper flash. But I can love with that. Look how much brighter the right one is. That is the old bulb. I got what I paid for from amazon. AWE :censored: !!!

Which one is the LED, the passenger side blinker or the driver side blinker?
 
Well unfortunately they did not carry what I needed. But I did get confirmation that I had the correct part. I will order one online i guess. I also located the flasher relay its in the Driver side kick panel just FYI
Hey gigerunner, when you install new electronic flasher, might you post a photo of the original flasher in its location. Thanks, I don't want to pull(rip) out wrong component.
 
i did an led swap all around on the outside of my 92. i had to install load resistors for the turn signals fornt and back, but total cost was less than 25$ off amazon. 4 load resistors were 5$ and each led was less than 4$, plus s&h and tax. but when i installed the led brake lights i came into a small issues. if all my lights are off and i press my brake pedal, my parking lights come on, including dash lights. its kind of annoying and a little embarrasing. so i usually just turn on my parking lights when i begin driving (those are led too) any ideas on why my circuits are mixing up?
 
I got a pair of shitty brake LED's that somehow turned off the running lights when brakes applied. I put the incandescent back in. I am ordering a more expensive pair now.
 
I only skimmed the post. But I did a total LED light replacement on my 85 86 87 88 pisa runner and I just opend the blinker relay and cut out the little resistor out that is for low voltage warning (ie blown bulb ) and it worked perfect. There is a wright up on it in Toyota 4wd owner mag.
 

Members online

No members online now.

Forum statistics

Threads
278,316
Messages
3,554,111
Members
248,016
Latest member
Advally Service

Trending content

Back
Top