Tyler James Inc
Senior Member
Yeah, combine shipping on mine too [emoji12]
What are these "other creations" you speak of?!
Sent from my iPhone using Tapatalk
What are these "other creations" you speak of?!
Sent from my iPhone using Tapatalk
I'm in for a drop bracket.![]()
Dang - awesome work!
I'd be in for both brackets. I have about 4.5" of lift and an adjustable panhard. My ssssswaaaaay sux because I have not dialed in any alignment on the rear.
Looking forward to hearing on pricing and shipping dates
Cheers
Mark
[QUOTE On a side note, are we certain that Toyota centered the axle on the 4Runner in the first place?
Driveshaft hitting tank has nothing to do with the panhard. On stock rig the rear tires lift off the ground way before the driveshaft has a chance to contact. Usually 3" lift coils won't cause much contact. It's the bigger coils.
So it's down-travel on the passenger side causing the driveshaft to swing over and contact the tank at a spot LOWER than the driveshaft normally is?
In other words; this occurs when the driver's side is stuffed and the passenger's side is extended?
So combination of leveled panhard, lowered bump stops, sway bar installed and some cutting of gas tank skid may stop the contact.
My contact is minimal. Maybe leveling out panhard will finally stop all contact.
The panhard has a big effect on how much the driveshaft hits the gas tank skid. The panhard is obviously not the cause of this, but it can push or pull the axle closer or further from making contact. Of course sway bars and extended bump stops will help cure this issue but those both limit offroad capabilities. The higher the the roll center the more swing the axle with have side to side under articulation. Think of a triangle with the top part as the axis of rotation (Roll Center) and the bottom as the axle. If the RC is low (on the same plane as the axle) the axle will rotate around the center of the differential. Now raise the roll center say a foot. The axle will now swing in more of an arc rather than just rotate around its own center. So if the RC is raised (pandhard lift bracket), the driveshaft will actually swing more into the gas tank skid. With the RC lowered (panhard drop bracket), the driveshaft will have less swing towards the gastank skid. Also if you went with just adjustable and no brackets, you would have to extend your PH to center your axle, which actually pushes it closer to the gas tank skid. I know roll center and all those other suspension terms can get confusing. Which it was very confusing for me when I first started learning about linked suspension. If my description doesn't make sense, then start searching to get a better understanding. Hope this helps though.
[MENTION=118730]AssBurns[/MENTION] what did you discover with fuel tank skid contact after you installed your PB lift bracket? I also noticed on [MENTION=67615]Dirtco[/MENTION]'s thread, on his very custom rear axle, that he made a axle side lift bracket which is even taller than yours and [MENTION=28464]eimkeith[/MENTION]s, I wonder if he had contact.
Well I originally made a PB drop bracket when i first installed my lift. I barely made any contact with my skid so I just hammered it a bit and it cleared. Once I cut off my drop bracket and made a lift bracket, I now rub my skid all over the place. I haven't done much to my skid yet since it just keeps getting bent up worse from smashing on it and hitting the driveshaft. I just grabbed pliers and bent the edge of the skid over then hammered it flat. Looks like shit but so does the rest of the skid. If I end up dropping the frame side a little to get the PH more level, then I'm sure it will help a little bit.