Pulled in to the parking garage at work a short while ago, hit 14k:
Congrats on the 14k but what I wanna know is how you pulled of almost 20mpg!!! lol
Pulled in to the parking garage at work a short while ago, hit 14k:
Congrats on the 14k but what I wanna know is how you pulled of almost 20mpg!!! lol
What parts did you go with?Installed a Dobinson 3" lift on the truck and added 275/70R17 BFG K02. Before the lift I measured the front wheel well at 34.25 and she sits at 37.25. Plan on getting it out this weekend and flexing the suspension.
What parts did you go with?
Marine,
Below is the parts list I went with on the truck!! All ordered from Dobinsons.
C59-300 COIL SPRINGS
GS59-700 GAS STRUT
SC59-001 STRUT TOP PLATE
C59-505 COIL SPRINGS
GS59-701 SHOCK ABSORBER
Installed a Dobinson 3" lift on the truck and added 275/70R17 BFG K02. Before the lift I measured the front wheel well at 34.25 and she sits at 37.25. Plan on getting it out this weekend and flexing the suspension.
Finally did a couple things I’ve been meaning to today.
1) Removed the running boards. Definitely looks a lot better, and looks like clearance will be greatly improved. I’m sure my wife and son will complain tomorrow... They liked the step. I will get sliders with a step eventually...
2) ARB Diff Breather Mod. This was kind of a big one for me. Bought the kit a while ago and watched a couple videos several times... Finally got up the nerve to do it. Felt really good!
Slapped the sexy new wheels on. I think I like them [emoji16]
I've only driven them around at about 35 miles per hour so far, but I can definitely notice a difference in handling. I also very much notice how much they stick out compared to the stock TRD off-road wheels - really digging it. Anyone else notice a difference in handling?![]()
![]()
Installed a Dobinson 3" lift on the truck and added 275/70R17 BFG K02. Before the lift I measured the front wheel well at 34.25 and she sits at 37.25. Plan on getting it out this weekend and flexing the suspension.
Was wondering if anyone would be able to check my compressor plan
175psi seems a bit steep for your safety valve. Something near 120 might be better in the event something does go wrong.
The check valve seems like an unnecessary point of failure and the drain should be on the tank.
I'm no expert on the matter but that's what looks somewhat unusual to me.
are you planning to get aftermarket UCA's with the 3" lift?
Looks great! Is there a reason you didn't go 285?