Horn install

[VT4runnin]

I probably should have included this in the FIAMM Horn Install thread but my issue is kind of seperate. I'm trying to install the El Grande Fiamm horn that will sit on the right however I don't have enough cabling. If you imagine looking straight at the two horns, the horn on the right has the connector at 2oclock. The cable won't reach all the way around to connect. If it were at 8 oclock I would be fine, however that means turning the horn upside down which wouldn't work. Did anyone run into the same issue or know of a good fix? Can I buy an cable extender online?

 

[Jtraskell]

I probably should have included this in the FIAMM Horn Install thread but my issue is kind of seperate. I'm trying to install the El Grande Fiamm horn that will sit on the right however I don't have enough cabling. If you imagine looking straight at the two horns, the horn on the right has the connector at 2oclock. The cable won't reach all the way around to connect. If it were at 8 oclock I would be fine, however that means turning the horn upside down which wouldn't work. Did anyone run into the same issue or know of a good fix? Can I buy an cable extender online?

Can you send picks of the horn? With that, somebody might be able to give you some advice.

 

[tx 4runner]

I probably should have included this in the FIAMM Horn Install thread but my issue is kind of seperate. I'm trying to install the El Grande Fiamm horn that will sit on the right however I don't have enough cabling. If you imagine looking straight at the two horns, the horn on the right has the connector at 2oclock. The cable won't reach all the way around to connect. If it were at 8 oclock I would be fine, however that means turning the horn upside down which wouldn't work. Did anyone run into the same issue or know of a good fix? Can I buy an cable extender online?

Cable extender? If you don't have enough wire, all you need are some of these and some 16 ga electrical wire, available at Radio Shack, or probably Pep Boys or Autozone.

 

[VT4runnin]

Cable extender? If you don't have enough wire, all you need are some of these and some 16 ga electrical wire, available at Radio Shack, or probably Pep Boys or Autozone.

LOL, yeah I'm not very mechanic savvy. By cable extender I just meant a new male/female piece with extra wire to extend the current wire. I'll stop by Autozone today to see if they have it. Thanks!

 

[VT4runnin]

Can you send picks of the horn? With that, somebody might be able to give you some advice.

Horns on Flickr - Photo Sharing!

Hope that pic works. So the wire stretching to the horn on the right is maxed out there. The old horn has the connector at about 8 oclock so it reaches. The new horn connector sits at 2 oclock and the wire wont stretch around the horn to connect.