Post your LIFTED pix here!
- Thread starter B'klyn_Mike
- Start date
kammando808
New member
No problem, these are the procomp 34 series
*Wheel Size: 18x9
*Offset: 0
*Backspace: 5
*Max Load: 2200
Meyercord
New member
All 4 bilsteins with OME 885 up front and toytec HD coils in the rear rolling on 285/65/18 with very minor trimming up front
Highest setting upfront? Looks great!
Orangutan
New member
Thank you, I do appreciate reply.
Standing Tall
Well ok I got the ICON Stage 2 (Tubular UCA) installed- didn't know I needed the rear track bar so that slowed the install down by a few days :shrug: and blacked out some of the chrome (LINEX Spray). First few pics are stock last few are after a few minor mods.
Well ok I got the ICON Stage 2 (Tubular UCA) installed- didn't know I needed the rear track bar so that slowed the install down by a few days :shrug: and blacked out some of the chrome (LINEX Spray). First few pics are stock last few are after a few minor mods.
Attachments
Hippiestrail
New member
Sweet looking rig bro ....very inspirational
CombatBevo
New member
Nice.... How are the 285 KO2s working out on the TRD Pro Wheel- I originally wanted the 285s but didn't think they would fit on the 7 inch wheel. I opted for the 275 KO2s but def like your set up.
CombatBevo
New member
They’re working just fine. I went with the Long Travel set-up, so I actually got 3”+ out of the lift (heavier overland springs in the rear) the difference is only 1/4” higher in the rear; barely noticeable. No wobble or vibration that I’ve noticed so far, but we’ll see once I get it up over 70mph tomorrow…...
carlomagne
New member
I can finally post in here
Cheers!
Member
I can finally post in here
Let's see some pics of the wheels. Are those the new 17" SCS F5s?
carlomagne
New member
carlomagne
New member
Thanks!
Diesel
New member
carlomagne
New member
Icon suspension/UCA
SCS F5 17x8.5 -10mm offset with spidertrax 1.25" spacers on all 4 corners
285/70/17 nitto trail grapplers
Diesel
New member
Thanks! Nice setup.
Body mount chop?
If not...what other mods to get that fit with -10 wheels and the spacers?
Badass.
carlomagne
New member
I trimmed some of the bumper and did the front fender liner mod.
I'll be doing a body mount chop soon and a little more trimming.
LawnDart
Senior Member
We trimmed a little bit of the bumper, not much. Got a photo of your trim job?
So far I'm not hearing any rubbing once I removed the front mudflaps, which were full on rubbing, so bad on my way down to CA I stopped to get coffee and reversed, and it sucked the right flap up against the tire and I damn near had to cut it off with my pocket knife.
But so far no rubbing on the body mount, even when I was sliding down a hill at the off road park.
I'm going to install upgraded bump stops because it's cheap insurance. The Bushwacker flares should be out soon, but those won't really improve any clearance issues.
